After getting everything back together, My vehicle still would not start. How ever, I was not able to fix the problem. I replaced the fuel pump and the fuel pump module on my 2005 Ford F150. I was having fuel pump issues and with your videos I was able to work on the issues.
2005 expedition fuel pump module how to#
One thought on “ How To Bypass Ford Fuel Pump Driver Module” Have you had to wire a jumper for a Ford fuel pump driver module? Let us know your thoughts below. If the fuel pump is not working, be sure to check for 12-volts on the white wire, or the jumper will not work as the module may be good.Ĭommon Ford OBDII codes for a bad module include P1237 Fuel Pump Secondary Circuit Malfunction and PO191 Fuel Rail Sensor. The jumper is likely the same across many types, but it is best to check a diagram to be sure. Jumpering a 2008 Ford F-150 fuel pump driver module is straightforward by sending 12-volt and ground to the fuel pump.įirst, Google a wiring diagram for your Ford to be sure the wiring is the same. Jumper the grounds together and the 12-volts to the 12-volt for the fuel pump will bypass the module.īasically, the outer left pins and outer right pin are jumpered together. The black/yellow wire is fuel pump ground, while the pink/black wire is 12 volts for the fuel pump. The outer wires of the plug are 12-volts from the battery (white) and module ground (brown). The pins are not numbered in a line, so it can be a bit confusing but below is how it is wired.īe sure to see a diagram for the make, year, and model of your Ford, as there may be variations.
How To Bypass 2008 Ford F-150 Fuel Pump Driver Module While I did not have any Issues, I Can Not Be Responsible If Something Goes Wrong. There is an inertia switch on the passenger side of the 2008 Ford F-150 that controls the fuel pump along with relays in the fuse box.ĭo the Following at Your Own Risk. The fuel pump driver module is located at the rear of the vehicle.īefore bypassing the module be sure it is getting 12-volts DC or there is another problem.
2005 expedition fuel pump module code#
The code on an OBDII scan tool was a P1237 Fuel Pump Secondary Circuit Malfunction. I recently ran into this problem with a 2008 Ford F-150 that had a fuel issue. This can be a good way to test if the module is bad or possibly get the vehicle home in an emergency. If you have a Ford that uses a fuel pump driver module, it can be bypassed for testing.
0 kommentar(er)
